Sign up for our newsletter:

Finishing Lab

The finishing of fabric is then done on state of the Art finishing range both Open width line and tubular line from MUZZI.

Padder

Thanks to cluster technologies gives even padding of softener and for all specialty finish make the fabric of required quality. Latest technology to avoid crease marks in all fabrics.

Relax drier of three chamber take care the highest shrinkage controls both on width and length and taken care dying stage itself. Excellent handle of fabric delivers after drier.

Muzzi Compactor Both Openand Tubular

Highly effective compaction system, taken care of all shrinkage problem of customer assures shrinkage level well below 5% nearly in all fabric structure. Thanks to the felt compaction system keep the fabric soft and undisturbed fabric structure.

Compactions with MUZZI align the fabric loops in line and stretch the fabric evenly without forming any hard crease on the fabric. The leveling, steaming and compacting calendar perfects the finishing of knitted fabrics in open width.

Its creates the mechanical prerequisites for the highest quality standards in wide-knitted fabrics, by ensuring the results of the prior shrinkage treatment and using controlled compressive shrinkage in a compacting calendar.

Binco Slitter

An accurate and auto sensing cutter align the fabric straight and cut the fabric neatly as per the slit line. Thanks to the highly sensitive sensor activate and alive the fabric and cut.

Stenter

The fabric entry section of a two padder system along with Weft Straightener that correct weft bowing in fabric fulfils the vision of modern textile machinery engineering.

The stenter and heat setting frame generation will state of the art technology in the detail for the cost-reducing, quality-promoting, thermal treatment of knitted fabric. Thanks to EHWA special features on its stenter.

1. Assures no condensation, and eliminates the chances of drops on fabric.
   
   
2. Controlled fabric guidance through DETECTOR, upper, lower air flow control and position the fabric always at the middle and avoid sagging during stenter and thus facilitate the even heat setting all along the fabric.
   
   
3. thanks to air nozzle system, where the fabric on the air streams and soft, voluminous hand and excellent residual shrinkage are achived.
   
   
4. Program control system, latest software technology fulfils almost every requirement, also production planning and production control.
   
   
5. Thanks split air system for individual, independently control temperature profile during the treatment process enable to deliver highest quality needs
   in surface coating process.